Some matters polishing machine in a matter of routine maintenance that need attention
release time: 2017-05-31 Click times: 27447
When using the polishing machine, we should pay attention to what matters?
After polishing machine is turned on the machine, the workpiece down by less polished and more into the barrel, the number and weight of the workpiece and the workpiece size and to have a relationship, so slowly into the workpiece to increase the workpiece rotation slowed down, but not workpiece does not move, do not move when the workpiece rotation, polishing liquid out of the product will be uneven, polishing time will also unnecessarily lengthened.
When using stainless steel polishing machine Do liquids and water, splashing into the wires and plugs.
In W models need to install overcurrent unit power switch, suggested the use of more than 10A.
After the power is turned attention to see the back of the cold cooling fan is running.
P-type machines do not work in the long low frequencies, lightning may cause damage to the machine.
Want to extend the life of the polishing machine, routine maintenance is very important, polishing barrels leaking bottom barbed needles available polished pliers to remove, add a little glue on the timer is not flashing, failure to start the switch, according to timing. Please change the water (normal temperature range of 50 ° C) when superheated water polishing bucket. Machine vibrations, check the machine is in force at each corner position, adjust the length. Also indicates normal, but the machine does not work, check the voltage is lower than 220V; polished needle placement is excessive.